User Tools
Sidebar
documentation:electronics:start
This is an old revision of the document!
FTDI-USB
The FTDI-USB is a board that implements similar functionalities of an FTDI cable. Hosting the FT230X, the board can basically convert from USB to serial and can be used for the communication with your board, your sensors etc. It is also compatible with UPDI programming. The board has been designed in KiCAD by using the fab libraries.
Only few components are needed to host the FT230X, as you can see below the board schematic.
Downloads
documentation/electronics/start.1613466419.txt.gz · Last modified: 2021/02/16 09:06 by daniele
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
