This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
projects:diysolderingfumeextractor [2021/11/22 18:38] daniele |
projects:diysolderingfumeextractor [2021/11/22 18:44] (current) daniele [Assembly procedure] |
||
---|---|---|---|
Line 69: | Line 69: | ||
====== Assembly procedure ====== | ====== Assembly procedure ====== | ||
- | - Position the inner supports and the M4 nuts | + | - Position the inner supports and the 6 x M4 nuts |
- | - | + | - Glue the lock surface on top of the nuts |
+ | - Screw the fan to the Fan Support, by making sure to have both protection grids installed, use the M4 60mm screws | ||
+ | - Assembly the main body | ||
+ | - Add a thin layer of G4 on the back of the fan | ||
+ | - Add the active carbon | ||
+ | - Add the F8/ filter | ||
+ | - Add the F8/9 filter | ||
+ | - Screw the Air Inlet using the M4 30mm screws | ||
+ | - Attach the Motor Controller to the top side of the control box, using 8 x M3 8mm screws and 4 x 10mm M3 StandOffs | ||
+ | - Pass the cables through the cable gland | ||
+ | - Screw the cable gland to the back of the control box | ||
+ | - Assembly the control box | ||
+ | |||
+ | {{: | ||
====== Final BOM ====== | ====== Final BOM ====== |