Differences

This shows you the differences between two versions of the page.

--- projects:diysolderingfumeextractor [2021/11/22 18:33]
daniele [Final Design]
+++ projects:diysolderingfumeextractor [2021/11/22 18:44] (current)
daniele [Assembly procedure]
@@ Line 56: / Line 56: @@
 Downloads:
-Fusion File:
+**Fusion File:[[ https://a360.co/3nI6aXQ]]**  \\
-**Step File: {{ :projects:diy_soldering_filter.zip |}}**
+**Step File: {{ :projects:diy_soldering_filter.zip |}}**\\
-**Drawing PDF:{{ :projects:diy_soldering_filter_final_drawing.pdf |}}**
+**Drawing PDF:{{ :projects:diy_soldering_filter_final_drawing.pdf |}}**\\
@@ Line 64: / Line 64: @@
 {{:projects:drawing.jpg?800|}}
-====== Final Results ======
 {{{{:projects:fab_filter.jpeg?600|}}}}
+====== Assembly procedure ======
+  - Position the inner supports and the 6 x M4 nuts
+  - Glue the lock surface on top of the nuts
+  - Screw the fan to the Fan Support, by making sure to have both protection grids installed, use the M4 60mm screws
+  - Assembly the main body
+  - Add a thin layer of G4 on the back of the fan
+  - Add the active carbon
+  - Add the F8/ filter
+  - Add the F8/9 filter
+  - Screw the Air Inlet using the M4 30mm screws
+  - Attach the Motor Controller to the top side of the control box, using 8 x M3 8mm screws and 4 x 10mm M3 StandOffs
+  - Pass the cables through the cable gland
+  - Screw the cable gland to the back of the control box
+  - Assembly the control box
+{{:projects:assembly_gif.gif?800|}}
 ====== Final BOM ======

FabLab Kamp-Lintfort