User Tools
projects:diysolderingfumeextractor
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
projects:diysolderingfumeextractor [2021/11/22 18:38] daniele |
projects:diysolderingfumeextractor [2021/11/22 18:42] daniele [Assembly procedure] |
||
|---|---|---|---|
| Line 69: | Line 69: | ||
| ====== Assembly procedure ====== | ====== Assembly procedure ====== | ||
| - | - Position the inner supports and the M4 nuts | + | - Position the inner supports and the 6 x M4 nuts |
| - | - | + | - Glue the lock surface on top of the nuts |
| + | - Screw the fan to the Fan Support, by making sure to have both protection grids installed, use the M4 60mm screws | ||
| + | - Assembly the main body | ||
| + | - Add a thin layer of G4 on the back of the fan | ||
| + | - Add the active carbon | ||
| + | - Add the F8/ filter | ||
| + | - Add the F8/9 filter | ||
| + | - Screw the Air Inlet using the M4 30mm screws | ||
| + | - Attach the Motor Controller to the top side of the control box, using 8 x M3 8mm screws and 4 x 10mm M3 StandOffs | ||
| + | - Pass the cables through the cable gland | ||
| + | - Screw the cable gland to the back of the control box | ||
| + | - Assembly the control box | ||
projects/diysolderingfumeextractor.txt · Last modified: 2021/11/22 18:44 by daniele
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
