FabLab Kamp-Lintfort

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

===== Ultimaker S5 (01) =====

^ Problem                                       ^ Description                                                                                                                                                                            ^  Maintenance  ^ Date        ^ Name   ^
| Filament sensor does not work                 | During long prints it stops saying that the filament is empty, even though it isn't. Reloading the filament does not help. Right now the filament sensor is disabled in the settings.  |               | 16.06.2021  | Ferdi  |
| Does not preheat prior to unloading material  | When changing material, it starts retracting before fully heating up the hotend. The heater starts blinking orange (heats up) but it starts retracting after a few seconds.            |               | 16.06.2021  | Ferdi  |

FabLab Kamp-Lintfort

User Tools

Site Tools

Page Tools