This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
documentation:machines:epilogzing [2021/05/27 11:46] ferdi |
documentation:machines:epilogzing [2021/06/07 14:24] (current) ferdi Add Plywood |
||
---|---|---|---|
Line 18: | Line 18: | ||
- move the machine by hand to the desired 0 location | - move the machine by hand to the desired 0 location | ||
- press the " | - press the " | ||
- | - send the file | + | - unfold the z-focus tool |
- | - | + | - press the button for adjusting the bed height |
+ | - press the up/down buttons until the focus tool touches the surface of the material | ||
+ | - press the reset button | ||
+ | === adjust the settings for speed/ | ||
+ | |||
+ | === send the file === | ||
+ | - see instructions for Rhino/ | ||
+ | - the name of the file should appear in the display | ||
+ | === turn on extraction === | ||
+ | - press the power button on the Filter | ||
+ | === cut === | ||
+ | - press the play button | ||
+ | - monitor the cut for possble flames (stop if there is any flame!) | ||
+ | - stay close to the machine while cutting | ||
+ | - once the cut if finished, open the cover and verify if the material is cut (without moving the material!" | ||
===== Rhino ===== | ===== Rhino ===== | ||
Line 45: | Line 59: | ||
===== Schnitt ===== | ===== Schnitt ===== | ||
- | ^ Material | + | ^ Material |
- | | Acryl | 3mm | 45 | 90 | 5000 | | | + | | Mdf with coating |
- | | Gummi | + | | Acryl | 3mm |
- | | Felt | 4mm | 100 | 40 | 500 | + | | Gummi |
+ | | Felt | 4mm | ||
+ | | Plywood | ||