User Tools
documentation:machines:epilogzing
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
documentation:machines:epilogzing [2021/05/03 14:32] ferdi [Table] |
documentation:machines:epilogzing [2021/06/07 14:24] (current) ferdi Add Plywood |
||
|---|---|---|---|
| Line 6: | Line 6: | ||
| [[https:// | [[https:// | ||
| [[machines: | [[machines: | ||
| + | |||
| + | ===== general Instructions ===== | ||
| + | === Turning on === | ||
| + | - Turn the machine on | ||
| + | - hang the exhaust tube out the window | ||
| + | |||
| + | === place and zero the material === | ||
| + | - place a piece of material | ||
| + | - press the xy/lock symbol (x/y disabled) to disable the motors | ||
| + | - turn the laserpointer on | ||
| + | - move the machine by hand to the desired 0 location | ||
| + | - press the " | ||
| + | - unfold the z-focus tool | ||
| + | - press the button for adjusting the bed height | ||
| + | - press the up/down buttons until the focus tool touches the surface of the material | ||
| + | - press the reset button | ||
| + | === adjust the settings for speed/ | ||
| + | |||
| + | === send the file === | ||
| + | - see instructions for Rhino/ | ||
| + | - the name of the file should appear in the display | ||
| + | === turn on extraction === | ||
| + | - press the power button on the Filter | ||
| + | === cut === | ||
| + | - press the play button | ||
| + | - monitor the cut for possble flames (stop if there is any flame!) | ||
| + | - stay close to the machine while cutting | ||
| + | - once the cut if finished, open the cover and verify if the material is cut (without moving the material!" | ||
| + | |||
| ===== Rhino ===== | ===== Rhino ===== | ||
| Line 30: | Line 59: | ||
| ===== Schnitt ===== | ===== Schnitt ===== | ||
| - | ^ Material | + | ^ Material |
| - | | Acryl | 3mm | 45 | 90 | 5000 | | | + | | Mdf with coating |
| - | | Gummi | + | | Acryl | 3mm |
| - | | Felt | 4mm | 100 | 40 | 500 | + | | Gummi |
| + | | Felt | 4mm | ||
| + | | Plywood | ||
| ===== Gravierung ===== | ===== Gravierung ===== | ||
| - | ^Material^Speed^Power^Freq.^Einsatz| | + | ^ Material |
| + | | Felt | 100 | 30 | ||
documentation/machines/epilogzing.1620052369.txt.gz · Last modified: 2021/05/03 14:32 by ferdi
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
