FABACADEMY2020 - WEEK 3

Emerging Objects
Miriam Choi
Mohammad-sharif
FabAcademy Lena Hagenauer
construction kit - YouTube
World of Books http://digitalgastronomy.co/
Piotr Bejenka Fab Academy 2020 Week 03
4. Computer controlled cutting - Arman Najari Fab Academy
hawra
Thunder Laser
Wala'a Nezar Welcome
Week 03. Computer-Aided Design
W03 Computer-controlled cutting - Hideo "HARU" Oguri - Fab Academy 2020
Vinyl Cutting a Logo from Scrap Bits of Vinyl - YouTube
4. Computer controlled cutting - Dan "MeisterTek" Meyer
Fab Academy - Jamagax

Alessa 2019
EEVblog #186 - Soldering Tutorial Part 3 - Surface Mount
WinAVR new link \

Electronics Production Local Lecture
Eagle to PCB-mill

It may happen that the thermal pads are too tiny to be milled, and they are not accessible by the end mills and therefore not shown in the FabModules path. To fix this issue you can increase their size in DRC→supply.

Another issue could be the isolation spacing between the traces (what you call tracks) and the ground layer. You can increase that by changing the isolation into the polygon properties.

How do I reach this “Properties” dialog box for the polygon?
Right click on the edge of the polygon then properties.