This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
projects:diysolderingfumeextractor [2021/11/22 18:07] daniele |
projects:diysolderingfumeextractor [2021/11/22 18:44] (current) daniele [Assembly procedure] |
||
|---|---|---|---|
| Line 54: | Line 54: | ||
| + | Downloads: | ||
| - | {{: | + | **Fusion File:[[ https:// |
| + | **Step File: {{ : | ||
| + | **Drawing PDF:{{ :projects:diy_soldering_filter_final_drawing.pdf |}}**\\ | ||
| - | ====== Final Results ====== | + | {{: |
| + | {{: | ||
| {{{{: | {{{{: | ||
| + | |||
| + | |||
| + | ====== Assembly procedure ====== | ||
| + | |||
| + | - Position the inner supports and the 6 x M4 nuts | ||
| + | - Glue the lock surface on top of the nuts | ||
| + | - Screw the fan to the Fan Support, by making sure to have both protection grids installed, use the M4 60mm screws | ||
| + | - Assembly the main body | ||
| + | - Add a thin layer of G4 on the back of the fan | ||
| + | - Add the active carbon | ||
| + | - Add the F8/ filter | ||
| + | - Add the F8/9 filter | ||
| + | - Screw the Air Inlet using the M4 30mm screws | ||
| + | - Attach the Motor Controller to the top side of the control box, using 8 x M3 8mm screws and 4 x 10mm M3 StandOffs | ||
| + | - Pass the cables through the cable gland | ||
| + | - Screw the cable gland to the back of the control box | ||
| + | - Assembly the control box | ||
| + | |||
| + | |||
| + | {{: | ||
| ====== Final BOM ====== | ====== Final BOM ====== | ||
| Line 66: | Line 90: | ||
| Total cost is about **60€** | Total cost is about **60€** | ||
| - | ^ Item ^ Picture | + | ^ Item ^ Picture |
| - | | **MS1238E12B-FHR-2EM** | + | | **MS1238E12B-FHR-2EM** |
| - | | **SC120-W5** | + | | **SC120-W5** |
| - | | **F8 / F9 Feinfilter matte** | + | | **F8 / F9 Feinfilter matte** |
| - | | **Pre filter G4 matte** | + | | **Pre filter G4 matte** |
| - | | **Active carbon 1kg** | {{https:// | + | | **Active carbon 1kg** | {{https:// |
| - | | **Hepa TE70TE15021 Hoover** | + | | **Hepa TE70TE15021 Hoover** |
| - | | **6mm Wood Sheet** | + | | **6mm Wood Sheet** |
| - | | **4mm Wood Sheet or MDF** | {{https:// | + | | **4mm Wood Sheet or MDF** | {{https:// |
| - | | **PLA Filament** | + | | **PLA Filament** |
| - | | **Cable Gland** | + | | **Cable Gland** |
| - | | **Superglue** | + | | **Superglue** |
| - | | **Power Supply** | + | | **Power Supply** |
| + | | Fasteners | ||