User Tools
documentation:machines:epilogzing
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
documentation:machines:epilogzing [2021/05/27 11:49] ferdi [Table] |
documentation:machines:epilogzing [2021/06/07 14:24] (current) ferdi Add Plywood |
||
|---|---|---|---|
| Line 18: | Line 18: | ||
| - move the machine by hand to the desired 0 location | - move the machine by hand to the desired 0 location | ||
| - press the " | - press the " | ||
| - | - send the file | + | - unfold the z-focus tool |
| - | - | + | - press the button for adjusting the bed height |
| + | - press the up/down buttons until the focus tool touches the surface of the material | ||
| + | - press the reset button | ||
| + | === adjust the settings for speed/ | ||
| + | |||
| + | === send the file === | ||
| + | - see instructions for Rhino/ | ||
| + | - the name of the file should appear in the display | ||
| + | === turn on extraction === | ||
| + | - press the power button on the Filter | ||
| + | === cut === | ||
| + | - press the play button | ||
| + | - monitor the cut for possble flames (stop if there is any flame!) | ||
| + | - stay close to the machine while cutting | ||
| + | - once the cut if finished, open the cover and verify if the material is cut (without moving the material!" | ||
| ===== Rhino ===== | ===== Rhino ===== | ||
| Line 45: | Line 59: | ||
| ===== Schnitt ===== | ===== Schnitt ===== | ||
| - | ^ Material | + | ^ Material |
| - | | Wood | + | | Mdf with coating |
| - | | Acryl | + | | Acryl |
| - | | Gummi | + | | Gummi |
| - | | Felt | 4mm | 100 | 40 | 500 | + | | Felt | 4mm |
| + | | Plywood | ||
documentation/machines/epilogzing.1622116159.txt.gz · Last modified: 2021/05/27 11:49 by ferdi
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
