User Tools
documentation:machines:easdlw6040
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
documentation:machines:easdlw6040 [2024/05/28 12:02] ahmed |
documentation:machines:easdlw6040 [2024/05/28 13:09] (current) ahmed |
||
|---|---|---|---|
| Line 129: | Line 129: | ||
| ===== Starting the job ===== | ===== Starting the job ===== | ||
| + | ===Turning ON extraction: | ||
| + | ===Turning ON Laser: === | ||
| + | The switch show below is used to allow power to go to the laser tube to generate the laser. You have to press the green button before sending the job otherwise the machine will move without the laser shooting out. This can be used to simulate the placement, scale of the cut, etc. before making the actual cut. | ||
| + | {{ : | ||
| + | ===Sending the Job: | ||
| Before starting the job make sure that the extraction filter is ON and that the laser is turned ON. | Before starting the job make sure that the extraction filter is ON and that the laser is turned ON. | ||
documentation/machines/easdlw6040.txt ยท Last modified: 2024/05/28 13:09 by ahmed
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
