This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
projects:diysolderingfumeextractor [2021/11/18 16:58] daniele [BOM] |
projects:diysolderingfumeextractor [2021/11/22 18:38] daniele |
||
---|---|---|---|
Line 13: | Line 13: | ||
- | ====== | + | ====== |
+ | This parts are here to document the design process, the final BOM and results are below. | ||
^ Item ^ Picture | ^ Item ^ Picture | ||
Line 52: | Line 53: | ||
====== Final Design ====== | ====== Final Design ====== | ||
- | ====== Final Results ====== | ||
- | ====== BOM ====== | + | Downloads: |
+ | |||
+ | **Fusion File:[[ https:// | ||
+ | **Step File: {{ : | ||
+ | **Drawing PDF:{{ : | ||
+ | |||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | {{{{: | ||
+ | |||
+ | |||
+ | ====== | ||
+ | |||
+ | - Position the inner supports and the M4 nuts | ||
+ | - | ||
+ | |||
+ | |||
+ | ====== Final BOM ====== | ||
Total cost is about **60€** | Total cost is about **60€** | ||
- | ^ Item ^ Picture | + | ^ Item ^ Picture |
- | | **MS1238E12B-FHR-2EM** | + | | **MS1238E12B-FHR-2EM** |
- | | **SC120-W5** | + | | **SC120-W5** |
- | | **F8 / F9 Feinfilter matte** | + | | **F8 / F9 Feinfilter matte** |
- | | **Pre filter G4 matte** | + | | **Pre filter G4 matte** |
- | | **Active carbon 1kg** | {{https:// | + | | **Active carbon 1kg** | {{https:// |
- | | **Hepa TE70TE15021 Hoover** | + | | **Hepa TE70TE15021 Hoover** |
- | | **6mm Wood Plate** | {{https:// | + | | **6mm Wood Sheet** | {{https:// |
- | | **PLA Filament** | + | | **4mm Wood Sheet or MDF** | {{https:// |
- | | **Cable Gland** | + | | **PLA Filament** |
- | | **Superglue** | + | | **Cable Gland** |
- | | **Power Supply** | + | | **Superglue** |
+ | | **Power Supply** | ||
+ | | Fasteners |