This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Last revision Both sides next revision | ||
documentation:machines:fablasermini [2022/03/01 16:00] daniele |
documentation:machines:fablasermini [2022/03/01 16:06] daniele |
||
---|---|---|---|
Line 154: | Line 154: | ||
The air filter must be set manually to the maximum power. | The air filter must be set manually to the maximum power. | ||
You can do that by pushing the filter button until the light becomes red. | You can do that by pushing the filter button until the light becomes red. | ||
+ | |||
+ | {{: | ||
+ | {{: | ||
+ | |||
+ | The air assist compressor will start automatically. You can check it by seeing it vibrate or if there is air coming out of the laser head. | ||
+ | If not please check if the compressor is connected to the electricy. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | Once all these pre-check have been done is tome to operate directly with the machine. | ||
+ | First check the focus distance with the focus tool. | ||
+ | The distance between the laser head and the material should correspond to the focus tool as shown below. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | If it is not the case you can remove the air assist pipe, unlock and rotate the head until it reaches the right distance. | ||
+ | Once done you must lock again the head, and reconnect the air assist pipe. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | |||