This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
projects:diysolderingfumeextractor [2021/11/18 17:07] daniele |
projects:diysolderingfumeextractor [2021/11/22 18:42] daniele [Assembly procedure] |
||
---|---|---|---|
Line 13: | Line 13: | ||
- | ====== | + | ====== |
+ | This parts are here to document the design process, the final BOM and results are below. | ||
^ Item ^ Picture | ^ Item ^ Picture | ||
Line 53: | Line 54: | ||
+ | Downloads: | ||
- | ====== Final Results ====== | + | **Fusion File:[[ https:// |
+ | **Step File: {{ : | ||
+ | **Drawing PDF:{{ : | ||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
{{{{: | {{{{: | ||
+ | |||
+ | |||
+ | ====== Assembly procedure ====== | ||
+ | |||
+ | - Position the inner supports and the 6 x M4 nuts | ||
+ | - Glue the lock surface on top of the nuts | ||
+ | - Screw the fan to the Fan Support, by making sure to have both protection grids installed, use the M4 60mm screws | ||
+ | - Assembly the main body | ||
+ | - Add a thin layer of G4 on the back of the fan | ||
+ | - Add the active carbon | ||
+ | - Add the F8/ filter | ||
+ | - Add the F8/9 filter | ||
+ | - Screw the Air Inlet using the M4 30mm screws | ||
+ | - Attach the Motor Controller to the top side of the control box, using 8 x M3 8mm screws and 4 x 10mm M3 StandOffs | ||
+ | - Pass the cables through the cable gland | ||
+ | - Screw the cable gland to the back of the control box | ||
+ | - Assembly the control box | ||
+ | |||
====== Final BOM ====== | ====== Final BOM ====== | ||
Line 62: | Line 88: | ||
Total cost is about **60€** | Total cost is about **60€** | ||
- | ^ Item ^ Picture | + | ^ Item ^ Picture |
- | | **MS1238E12B-FHR-2EM** | + | | **MS1238E12B-FHR-2EM** |
- | | **SC120-W5** | + | | **SC120-W5** |
- | | **F8 / F9 Feinfilter matte** | + | | **F8 / F9 Feinfilter matte** |
- | | **Pre filter G4 matte** | + | | **Pre filter G4 matte** |
- | | **Active carbon 1kg** | {{https:// | + | | **Active carbon 1kg** | {{https:// |
- | | **Hepa TE70TE15021 Hoover** | + | | **Hepa TE70TE15021 Hoover** |
- | | **6mm Wood Plate** | {{https:// | + | | **6mm Wood Sheet** | {{https:// |
- | | **PLA Filament** | + | | **4mm Wood Sheet or MDF** | {{https:// |
- | | **Cable Gland** | + | | **PLA Filament** |
- | | **Superglue** | + | | **Cable Gland** |
- | | **Power Supply** | + | | **Superglue** |
+ | | **Power Supply** | ||
+ | | Fasteners |