This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
documentation:electronics:hellod1614 [2021/02/16 13:29] daniele |
documentation:electronics:hellod1614 [2021/02/16 14:33] (current) daniele |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== HelloD1614 ====== | ====== HelloD1614 ====== | ||
- | Based on the [[http:// | + | Based on the [[http:// |
+ | {{: | ||
- | + | The board layout shows on the right side the connection to the FTDI cable, and to the bottom-right side the connection for the UPDI programmer. On the left side the I2C is exposed, also with 4.7k pull-up resistors. Additional IO is on the top. More details in the pinout. | |
- | {{: | + | |
{{: | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | Below the soldered board to identify the components: | ||
{{: | {{: | ||
Line 17: | Line 21: | ||
====== Programming ====== | ====== Programming ====== | ||
- | ** Windows and Arduino IDE ** | + | ====== |
- | | + | ** Add the the [[https:// |
- | - Open the Arduino IDE | + | Open the Arduino IDE\\ |
- | | + | Go to File -> Preferences: |
{{: | {{: | ||
| | ||
- | - Paste the following | + | Paste the following |
{{: | {{: | ||
- | - Go to Tools -> Board -> Board Manager | + | Go to Tools -> Board -> Board Manager: |
{{: | {{: | ||
- | - search | + | Search |
{{: | {{: | ||
- | - further | + | Further |
+ | ** Connect the board ** | ||
+ | To be programmed by using the UPDI, the board can be connected as shown below. Instead of the [[http:// | ||
+ | {{: | ||
+ | To connect the FTDI-USB is recommended to use an extension cable or a USB hub, as shown in the following picture: | ||
+ | ** Upload bootloader and code ** | ||
- | To be programmed by using the UPDI, the board can be connected as show below. Instead of the [[http:// | + | It is recommended to burn the bootloader prior the uploading of any other code. |
+ | To upload | ||
+ | |||
+ | {{: | ||
+ | |||
+ | To upload any code, the options from above will stay the same, the only difference is to just push the upload button instead of the Burn Bootloader option. | ||
- | {{: | ||
====== Downloads ====== | ====== Downloads ====== |