Differences

This shows you the differences between two versions of the page.

--- documentation:machines:easdlw6040 [2024/05/28 11:56]
ahmed
+++ documentation:machines:easdlw6040 [2024/05/28 13:09] (current)
ahmed
@@ Line 129: / Line 129: @@
 ===== Starting the job    =====
+===Turning ON extraction:===
+===Turning ON Laser: ===
+The switch show below is used to allow power to go to the laser tube to generate the laser. You have to press the green button before sending the job otherwise the machine will move without the laser shooting out. This can be used to simulate the placement, scale of the cut, etc. before making the actual cut.
+{{ :documentation:machines:easdlw6040:laserswitch.jpg?600 |}}
+===Sending the Job:===
+Before starting the job make sure that the extraction filter is ON and that the laser is turned ON.
 ===== Finalising the job    =====
+After the machine finishes the cut wait until all the smoke have cleared up, turn OFF the laser power, turn OFF the extraction filter, take your parts and dispose of the remaining material properly.
+If in doubt always ask the staff. Please report any abnormalities to the staff. Always be prepared to deal with fire in case a fire starts.

FabLab Kamp-Lintfort