This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
documentation:machines:epilogzing [2021/03/24 08:57] ferdi [Table] |
documentation:machines:epilogzing [2021/05/27 12:09] ferdi |
||
---|---|---|---|
Line 4: | Line 4: | ||
Working Area: 24" x 12" (610 x 305 mm)\\ | Working Area: 24" x 12" (610 x 305 mm)\\ | ||
Power: 30 Watt\\ | Power: 30 Watt\\ | ||
- | [[https:// | + | [[https:// |
+ | [[machines: | ||
+ | |||
+ | ===== general Instructions ===== | ||
+ | === Turning on === | ||
+ | - Turn the machine on | ||
+ | - hang the exhaust tube out the window | ||
+ | |||
+ | === place and zero the material === | ||
+ | - place a piece of material | ||
+ | - press the xy/lock symbol (x/y disabled) to disable the motors | ||
+ | - turn the laserpointer on | ||
+ | - move the machine by hand to the desired 0 location | ||
+ | - press the " | ||
+ | - unfold the z-focus tool | ||
+ | - press the button for adjusting the bed height | ||
+ | - press the up/down buttons until the focus tool touches the surface of the material | ||
+ | - press the reset button | ||
+ | === adjust the settings for speed/ | ||
+ | |||
+ | === send the file === | ||
+ | - see instructions for Rhino/ | ||
+ | - the name of the file should appear in the display | ||
+ | === turn on extraction === | ||
+ | - press the power button on the Filter | ||
+ | === cut === | ||
+ | - press the play button | ||
+ | - monitor the cut for possble flames (stop if there is any flame!) | ||
+ | - stay close to the machine while cutting | ||
+ | - once the cut if finished, open the cover and verify if the material is cut (without moving the material!" | ||
===== Rhino ===== | ===== Rhino ===== | ||
Line 31: | Line 60: | ||
^ Material | ^ Material | ||
+ | | Wood | 3mm | 70 | 60 | 500 | ||
| Acryl | 3mm | 45 | 90 | 5000 | | | | Acryl | 3mm | 45 | 90 | 5000 | | | ||
| Gummi | 0,7mm | 100 | 80 | 500 | cuts well but too much flame | | | Gummi | 0,7mm | 100 | 80 | 500 | cuts well but too much flame | | ||
+ | | Felt | 4mm | 100 | 40 | 500 | ||
===== Gravierung ===== | ===== Gravierung ===== | ||
- | ^Material^Speed^Power^Freq.^Einsatz| | + | ^ Material |
+ | | Felt | 100 | 30 | ||