This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
documentation:machines:epilogfusion [2021/01/12 10:41] ferdi |
documentation:machines:epilogfusion [2021/03/29 14:29] ferdi |
||
---|---|---|---|
Line 50: | Line 50: | ||
| Turn on the Filter | | Turn on the Filter | ||
- | | {{: | + | | {{: |
=== How to start the Job === | === How to start the Job === | ||
- | {{: | + | {{: |
- | Go to the **Job** function on the Control Panel.\\ | + | |
- | Press the **Go** key to start or resume a job.\\ | + | * Go to the **Job** function on the Control Panel.\\ |
- | Pressing the **Stop** key will stop the lens carriage and the laser beam will be shut off.\\ | + | |
- | Pressing the **Reset** key will move the carriage to its home position.\\ | + | |
+ | | ||
Line 239: | Line 240: | ||
[[# | [[# | ||
+ | |||
+ | ===== Inkscape ===== | ||
+ | In inkscape you have to make sure that your cutting lines are thinner than 0.0254 mm\\ | ||
+ | Instead of File --> print, you should use the "Win32 vector print" | ||
+ | {{: | ||
+ | or save as pdf and print the pdf from Acrobat reader.\\ | ||
===== Working with the Epilog Job Manager ===== | ===== Working with the Epilog Job Manager ===== | ||
Line 338: | Line 345: | ||
{{: | {{: | ||
+ | |||
+ | ===== letztes mal Linse geputzt ===== | ||
+ | 29.3.2021 Markus\\ | ||