This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
documentation:machines:epilogfusion [2021/01/12 10:17] ferdi |
documentation:machines:epilogfusion [2021/02/08 15:54] ferdi |
||
---|---|---|---|
Line 49: | Line 49: | ||
In the picture above the bottom of the **focus gauge** just touches the surface of the material. | In the picture above the bottom of the **focus gauge** just touches the surface of the material. | ||
- | === Turn on the Filter | + | | Turn on the Filter |
- | {{: | + | | {{: |
- | === Turn on the air Compressor === | ||
- | {{: | ||
=== How to start the Job === | === How to start the Job === | ||
- | {{: | + | {{: |
- | | + | |
- | | + | |
- | | + | |
- | | + | |
- | [[# | ||
===== Cutting Settings ===== | ===== Cutting Settings ===== | ||
Line 243: | Line 240: | ||
[[# | [[# | ||
+ | |||
+ | ===== Inkscape ===== | ||
+ | In inkscape you have to make sure that your cutting lines are thinner than 0.0254 mm\\ | ||
+ | Instead of File --> print, you should use the "Win32 vector print" | ||
+ | {{: | ||
+ | or save as pdf and print the pdf from Acrobat reader.\\ | ||
===== Working with the Epilog Job Manager ===== | ===== Working with the Epilog Job Manager ===== |