This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
documentation:electronics:start [2021/02/16 08:49] daniele |
documentation:electronics:start [2021/02/16 14:32] daniele |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | FTDI-USB | + | ====== |
+ | The FTDI-USB is a board that implements similar functionalities of an [[https:// | ||
+ | |||
+ | Only few components are needed to host the FT230X, as you can see below the **board schematic**: | ||
{{: | {{: | ||
+ | The **board layout** is similar to the old FabISP (with fewer components) or a USB drive. Take care the FT230 requires a 0.2mm end mill because of its small package: | ||
{{: | {{: | ||
+ | The board is designed to match the FTDI cable pinout, with the exception that the RTS and the CTS pins are not connected. To have a stable and safe connection be sure to add a small layer underneath the USB plug and to use either an USB extension cable or a USB hub. Below is the **pinout**: | ||
{{: | {{: | ||
+ | Here the ** soldered board **, useful to look up which components are needed: | ||
+ | {{: | ||
- | ====== Downloads ====== | + | {{: |
+ | ====== Downloads ====== | ||
- | | + | \\ |
- | * Traces PNG: | + | * **FTDI-USB KiCAD files in a zip:** {{ : |
+ | \\ | ||
+ | | ||
+ | \\ | ||
* {{: | * {{: | ||
- | | + | \\ |
+ | * **Holes PNG:** | ||
+ | \\ | ||
* {{: | * {{: | ||
- | | + | \\ |
+ | * **Cut PNG:** | ||
+ | \\ | ||
* {{: | * {{: | ||