This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
documentation:electronics:hellod1614 [2021/02/16 13:29] daniele |
documentation:electronics:hellod1614 [2021/02/16 13:45] daniele |
||
---|---|---|---|
Line 2: | Line 2: | ||
Based on the [[http:// | Based on the [[http:// | ||
- | |||
- | |||
{{: | {{: | ||
Line 17: | Line 15: | ||
====== Programming ====== | ====== Programming ====== | ||
- | ** Windows and Arduino IDE ** | + | ====== |
- | | + | ** Add the the [[https:// |
- | - Open the Arduino IDE | + | Open the Arduino IDE\\ |
- | | + | Go to File -> Preferences: |
{{: | {{: | ||
| | ||
- | - Paste the following | + | Paste the following |
{{: | {{: | ||
- | - Go to Tools -> Board -> Board Manager | + | Go to Tools -> Board -> Board Manager: |
{{: | {{: | ||
- | - search | + | Search |
{{: | {{: | ||
- | - further | + | Further |
+ | ** Connect the board ** | ||
+ | To be programmed by using the UPDI, the board can be connected as shown below. Instead of the [[http:// | ||
+ | {{: | ||
+ | To connect the FTDI-USB is recommended to use an extension cable or a USB hub, as shown in the following picture: | ||
+ | ** Upload bootloader and code ** | ||
- | To be programmed by using the UPDI, the board can be connected as show below. Instead of the [[http:// | + | It is recommended to burn the bootloader prior the uploading of any other code. |
+ | To upload | ||
+ | |||
+ | {{: | ||
+ | |||
+ | To upload any code, the options from above will stay the same, the only difference is to just push the upload button instead of the Burn Bootloader option. | ||
- | {{: | ||
====== Downloads ====== | ====== Downloads ====== |