This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
documentation:electronics:hellod1614 [2021/02/16 12:20] daniele |
documentation:electronics:hellod1614 [2021/02/16 13:45] daniele |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== HelloD1614 ====== | ====== HelloD1614 ====== | ||
+ | Based on the [[http:// | ||
{{: | {{: | ||
Line 8: | Line 8: | ||
{{: | {{: | ||
+ | |||
+ | Here's the board connected to the FTDI: | ||
{{: | {{: | ||
+ | ====== Programming ====== | ||
+ | |||
+ | ====== Windows and Arduino IDE ====== | ||
+ | |||
+ | ** Add the the [[https:// | ||
+ | |||
+ | Open the Arduino IDE\\ | ||
+ | Go to File -> Preferences: | ||
+ | |||
+ | {{: | ||
+ | | ||
+ | Paste the following link inside the Additional Boards Manager URLs: http:// | ||
+ | |||
+ | {{: | ||
+ | |||
+ | Go to Tools -> Board -> Board Manager: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | Search for megaTinyCore and install it: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | Further instructions here: https:// | ||
+ | |||
+ | ** Connect the board ** | ||
+ | |||
+ | To be programmed by using the UPDI, the board can be connected as shown below. Instead of the [[http:// | ||
{{: | {{: | ||
+ | |||
+ | |||
+ | To connect the FTDI-USB is recommended to use an extension cable or a USB hub, as shown in the following picture: | ||
+ | |||
+ | |||
+ | |||
+ | ** Upload bootloader and code ** | ||
+ | |||
+ | It is recommended to burn the bootloader prior the uploading of any other code. | ||
+ | To upload the bootloader, select the following options: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | To upload any code, the options from above will stay the same, the only difference is to just push the upload button instead of the Burn Bootloader option. | ||
+ | |||
====== Downloads ====== | ====== Downloads ====== | ||
Line 21: | Line 66: | ||
* **Traces PNG: | * **Traces PNG: | ||
\\ | \\ | ||
- | * | + | * {{: |
\\ | \\ | ||
* **Holes PNG: | * **Holes PNG: | ||
\\ | \\ | ||
- | * | + | * {{: |
\\ | \\ | ||
* **Cut PNG: | * **Cut PNG: | ||
\\ | \\ | ||
- | * | + | * {{: |